Description: Rear Tamper Fault. After the Rear Tamper started moving to the home position, the Rear Tamper Home Sensor did not turn On within 800ms.
Remedy: Manually operate the Tamper mechanism. The Tamper mechanism moves smoothly. Y↓ N→Replace the parts that are interfering with operation. Execute dc330 Component Control [012-221], Rear Tamper Home Sensor. Manually operate the Tamper mechanism to block and unblock the sensor. The display changes. Y↓ N→Check the wire between J8882 pin 2 and J8984 pin 8 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between J8984, pins 9 and 7 on the Finisher PWB (Tamping Control (2 of 2)). The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between J8984, pin 8 on the Finisher PWB and GNN (Tamping Control (2 of 2)). Manually operate the Tamper mechanism to block and unblock the Rear Tamper Home Sensor. The voltage changes. Y↓ N→Replace the Rear Tamper Home Sensor. Replace the Finisher PWB. Alternately execute dc330 Component Control [012-026], Rear Tamper Motor Front and [012- 029], Rear Tamper Motor Rear. The Rear Tamper Motor moves. Y↓ N→There is +24 VDC from J8984 pin 19 on the Finisher PWB to GND Y↓ N→There is +24 VDC from J8982 pin 4 on the Finisher PWB to GND Y↓ N→Go to Finisher Interlock Switching and check the +24V circuit feeding pin 4. Repair/reconnect as required. Replace the Finisher PWB. Check the wires between J8984, pins 13 ~ 17 on the Finisher PWB, and the Rear Tamper Motor P/J8883 for an open or short circuit, or a loose or damaged connector. The wires are OK. Repair/reconnect as required. Replace the Rear Tamper Motor. If the problem persists, replace the Finisher PWB. Replace the Finisher PWB.