Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.263 — Xerox Phaser 7800

Code: 312.263

Description: Rear Tamper Home Sensor On Fault. The Rear Tamper Home Sensor did not turn On within the specified time after the Tamper Motor had started running.
Remedy: • Rear Tamper Actuator for deformation • Rear Tamper Home Sensor for proper installation • Rear Tamper Home Sensor connectors • Rear Tamper Motor for proper operation • Rear Tamper Motor connectors
Enter dc330 Component Control [012-026] and [012-029], Rear Tamper Motor (PL 24.55 Item 9), alternately. Select Start. The Rear Tamper Motor runs. Y↓ N→Select Stop. Go to Finisher Tamper Control. Check circuit of the Rear Tamper Motor. Refer to Multiple Wire Motor RAP for troubleshooting procedure. Select Stop. Select [012-221], Rear Tamper Home Sensor (PL 24.55 Item 7). Select Start. Actuate the sensor with a piece of paper. The display changes. Y↓ N→Select Stop. Go to Finisher Tamper Control. Check circuit of the Rear Tamper Home Sensor. Refer to Transmissive Sensor RAP for troubleshooting procedure. Select Stop. If the problem continues, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie