Code: 312.265
Description: Booklet Folder Home Sensor Off Fault. When the Booklet Home moves from Home position, the Folder Home Sensor did not turn OFF within the specified time.
Remedy: • The Folder Home Sensor for improper installation • The Folder Home Sensor connectors for connection failure • The Booklet Fold Knife Motor connectors for connection failure • The Knife drive mechanism for a foreign substance
Enter dc330 Component Control [013-022], Folder Knife Motor FWD and [013-023], Folder Knife Motor REV alternately. Select Start. The Fold Knife Motor energizes. Y↓ N→Select Stop. Refer to Folder Control. Check continuity between the Folder Knife Motor ( P/J8905) and the Finisher PWB ( P8985), and between the Booklet PWB ( P/J8994) and the Finisher PWB ( P8985). The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Folder Knife Motor (PL 23.15). If the problem continues, replace the Booklet Maker PWB. Select Stop. Enter dc330 Component Control [13-101], Folder Home Sensor. Select Start. Block/unblock the Folder Home Sensor. The display changed. Y↓ N→Check the wire between J8904 pin 2 and P/J8990 pin 2 on the FInisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between P/J8990, pins 3 and 1 on the Finisher PWB Folder Control. The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between P/J8990, pin 2 on the Finisher PWB and GND (Folder Control). Block/unblock the Folder Home Sensor. The voltage changes. Y↓ N→Replace the Folder Home Sensor (PL 23.15 Item 16). Replace the Finisher PWB. If the problem continues, replace the Finisher PWB.
Enter dc330 Component Control [013-022], Folder Knife Motor FWD and [013-023], Folder Knife Motor REV alternately. Select Start. The Fold Knife Motor energizes. Y↓ N→Select Stop. Refer to Folder Control. Check continuity between the Folder Knife Motor ( P/J8905) and the Finisher PWB ( P8985), and between the Booklet PWB ( P/J8994) and the Finisher PWB ( P8985). The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Folder Knife Motor (PL 23.15). If the problem continues, replace the Booklet Maker PWB. Select Stop. Enter dc330 Component Control [13-101], Folder Home Sensor. Select Start. Block/unblock the Folder Home Sensor. The display changed. Y↓ N→Check the wire between J8904 pin 2 and P/J8990 pin 2 on the FInisher PWB for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between P/J8990, pins 3 and 1 on the Finisher PWB Folder Control. The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between P/J8990, pin 2 on the Finisher PWB and GND (Folder Control). Block/unblock the Folder Home Sensor. The voltage changes. Y↓ N→Replace the Folder Home Sensor (PL 23.15 Item 16). Replace the Finisher PWB. If the problem continues, replace the Finisher PWB.