Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.268 — Xerox Phaser 7800

Code: 312.268

Description: Booklet Rear Stapler Fault. The Booklet Rear Staple Home Switch is not On (does not return to home position) within the specified time after the Booklet Rear Staple Motor starts to reverse.
Remedy: Enter dc330 Component Control [12-026], Staple Motor FWD. and then [12-027], Staple Motor REV. The Front Booklet Stapler cycles normally. Y↓ N→There is +24 VDC from P/J8993 pin 5 on the Booklet PWB to GND. Y↓ N→Check the circuit from the Booklet PWB to the Booklet Stapler Cover Switch (Booklet Interlock Switching). Repair/replace as required (PL 23.21). Switch Off the power. Check the wires between P/J8995 on the Booklet PWB and J8895 on the Rear Booklet Stapler (Booklet Staple Control (2 of 2)) for a loose or damaged connector, or an open or short circuit. If the wires are OK, replace the Rear Booklet Stapler Assembly. If the problem remains, replace the Booklet PWB (PL 23.21). Switch Off the power. Check the wire between P/J8995, pin 12 on the Booklet PWB and J8895 pin 3 on the Rear Booklet Stapler (Booklet Staple Control (2 of 2)) for a loose or damaged connector, or an open or short circuit. If the wires are OK, replace the Rear Booklet Stapler Assembly. If the problem remains, replace the Booklet Maker PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie