Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.282 — Xerox Phaser 7800

Code: 312.282

Description: Eject Clamp Home Sensor Off Fault. Eject Clamp Home Sensor is not turned Off within a specified time.
Remedy: • Check for obstructions in the Clamp area
Enter dc330 Component Control [012-250], Eject Clamp Home Sensor (PL 23.11 Item 16). Select Start. Actuate the Eject Clamp Home Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Eject Drive. Check the circuit of the Eject Clamp Home Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select [012-052], Eject Clamp Motor (PL 24.34 Item 10). Select Start. The Eject Clamp moves up. Y↓ N→The Eject Motor energized. Y↓ N→Select Stop. Go to Finisher Eject Drive. Check the circuit of the Eject Clamp Motor. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Check the Eject Clamp Motor (PL 24.34 Item 10) and its associated gears, pulleys and belts for damage, contamination and misalignment. Select Stop. Check the following: • Ensure that the Eject Clamp Home Sensor connectors are securely connected and that the wires are not damaged. • Ensure that the Eject Clamp Motor connectors are securely connected and that the wires are not damaged. If the above checks are OK, replace the Eject Clamp Home Sensor. If the problem persists, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie