Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.284 — Xerox Phaser 7800

Code: 312.284

Description: Set Clamp Home Sensor Off Fault. BSD-ON: Set Eject Control (2 of 2) After the Set Clamp completed operation, the Set Clamp Home Sensor did not turn Off within the specified time.
Remedy: • Manually operate the Eject mechanism. Check for binding, a dirty sensor, or damage. • Check the Actuator for the Set Clamp Home Sensor for damage.
Execute dc330 Component Control [012-251], Set Clamp Home Sensor. Actuate the Set Clamp Home Sensor. The display changes. Y↓ N→Check the wire between J8881 pin 2 on the Set Clamp Home Sensor and P/J8988 pin 11 on the Finisher PWB for an open or short circuit, or loose or damaged connectors. The wire is OK. Y↓ N→Repair/replace as required. Measure the voltage between P/J8988, pins 12 and 10 on the Finisher PWB. The voltage is approx. +5VDC. Y↓ N→Replace the Finisher PWB. Measure the voltage between the pin 11 on the Finisher PWB and GND). Actuate the Eject Clamp Home Sensor. The voltage changes. Y↓ N→Replace the Eject Clamp Home Sensor (PL 23.11 Item 34). Replace the Finisher PWB. Alternately execute dc330 Component Control [012-052], Eject Clamp Up and [012-053], Eject Clamp Down. The Eject Motor starts. Y↓ N→Check the wires between P/J8878 pins 1~6 on the Eject Motor and P/J8983 pins 5~8 on the Finisher PWB for an open or short circuit, or loose or damaged connectors (Set Eject Control (1 of 2)). The wires are OK. Y↓ N→Repair/replace as required. Measure the resistance of the Eject Motor between each pin of P/J8878-1/3/4/6. The resistance is approx. 2Ohm. Y↓ N→Replace the Eject Motor. Replace the Finisher PWB. If the problem remains, replace the Eject Motor Execute dc330 Component Control [012-050 Set Clamp Clutch ON]. The Set Clamp Clutch energizes. Y↓ N→Select Stop. Check the wires between P/J8877 pins 1 and 2 on the Set Clamp Clutch and P/J8983 pins 3 and 4 on the Finisher PWB for an open or short circuit, or loose or damaged connectors (Set Eject Control (2 of 2)). The wires are OK. Y↓ N→Repair/replace as required. Measure the voltage between the Finisher PWB P8983-4 (+) and GND (-). The voltage is approx. +24VDC. Y↓ N→Replace the Set Clamp Clutch (PL 23.11 Item 12). If the problem persists, replace the Finisher PWB. Replace the Finisher PWB. Replace the Finisher PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie