Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.287 — Xerox Phaser 7800

Code: 312.287

Description: Decurler Cam Home Sensor Off Fault. Decurler Move Home Sensor is not turned off after the lapse of 1000msec from the detection of Decurler Cam Home Sensor On.
Remedy: • Check for obstructions in the Decurler area
Enter dc330 Component Control [012-282], Decurler Cam Home Sensor (PL 24.5 Item 4). Select Start. Actuate the Decurler Cam Home Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Decurling. Check the circuit of the Decurler Cam Home Sensor. Refer to the Transmissive Sensor RAP for troubleshooting procedure. Select Stop. Select [012-099], Decurler Cam Clutch (PL 24.5 Item 7). Select Start. The Decurler Roll Shaft rotates. Y↓ N→The Decurler Cam Clutch energized. Y↓ N→Select Stop. Go to Finisher Decurling. Check the circuit of the Decurler Cam Clutch. Refer to the Multiple Wire Motor RAP for troubleshooting procedure. Check the Decurler Cam Clutch (PL 24.5 Item 7) and its associated gears, pulleys and belts for damage, contamination and misalignment. Select Stop. Check the following: • Ensure that the Decurler Cam Home Sensor connectors are securely connected and that the wires are not damaged. • Ensure that the Decurler Cam Clutch connectors are securely connected and that the wires are not damaged. • H-Transport Motor Drive belt for wear, damage, or loose • H-Transport Motor connections are securely connected and that the wires are not damaged. If the above checks are OK, replace the Decurler Cam Home Sensor (PL 24.5 Item 4). If the problem continues, replace the H-Transport PWB (PL 24.44 Item 19). If the problem persists, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie