Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.291 — Xerox Phaser 7800

Code: 312.291

Description: Stapler Fault. The Staple Home Sensor has not switched from Off to On within the specified time after the Staple Motor had started rotating forward. The Staple Home Sensor did not turn On within the specified time after the Staple Motor had started rotating backward.
Remedy: • Check the Stapler Head for obstructions
Enter dc330 Component Control [012-046] and [012-047], Staple Motor, (PL 24.33 Item 9), alternately. Select Start. The Staple Motor runs. Y↓ N→Select Stop. Go to Finisher Stapler Control. Check continuity between the Stapler Head and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Stapler Unit. If the problem continues, replace the Finisher Main PWB. Select Stop. Select [012-244], Staple Home Sensor. Select [012-046] and [012-047], Staple Motor, (PL 24.33 Item 9), alternately. Select Start. The display changes Y↓ N→Select Stop. Go to Finisher Stapler Control. Check continuity between the Stapler Home Sensor and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Stapler Unit. If the problem continues, replace the Finisher Main PWB. Select Stop. Check the following: • The wire between the Staple Head and the Finisher PWB for damage If the above checks are OK, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie