Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.302 — Xerox Phaser 7800

Code: 312.302

Description: Finisher Front Cover Open.
Remedy: • Check the installation of the H-Transport Open Sensor • Opening/closing of the Finisher H-Transport Cover.
Execute dc330 Component Control [012-302], Front Door Interlock Switch. Open/close the Finisher Front Cover. The display changes. Y↓ N→Open the Front Door and cheat the Front Door Interlock Switch The display changes. Y↓ N→Check the wires between J8982 pin 3 and J8891 pin 2B, and from J8891 pin 2A to J8982 pin 3 for an open or short circuit, or a loose or damaged connector. The wires are OK. Y↓ N→Repair/reconnect as required. Remove the cheater. Measure the voltage between J8891 pin 2A on the Front Door Interlock Switch and GND (Finisher Interlock Switching). The voltage is approx. +5VDC. Y↓ N→Check the wire from J8891 pin 2A to J8982 pin 3 for an open or short circuit, or a loose or damaged connector. If the wires are OK, replace the Finisher PWB. Cheat the Interlock Switch. The voltage drops to 0 VDC. Y↓ N→Replace the Front Door Interlock Switch (PL 23.16). Replace the Finisher PWB. Check the actuator for damage or misalignment Check the Interlock circuit for an intermittent condition (Finisher Interlock Switching). If the problem continues, replace the Finisher PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie