Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 312.302 — Xerox Phaser 7800

Code: 312.302

Description: Finisher Front Door Interlock Open. Finisher Front Door Switch Open was detected.
Remedy: • Finisher Front Door Switch for proper installation • Finisher Front Door Switch connectors for connection failure • Actuator part for deformation • Ensure that the Eject Cover is in the closed/down position
Enter dc330 Component Control [012-302], Front Door Interlock Switch (PL 24.11 Item 2). Select Start. Open and close the Front Door. The display changes. Y↓ N→Go to Finisher Interlocks. Disconnect P8314 on the Finisher PWB. +5 VDC is measured between the Finisher PWB P8314-2 and P8314-3. Y↓ N→Replace the Finisher Main PWB. There is less than 5 ohms between P8314-3 and the finisher frame. Y↓ N→Replace the Finisher Main PWB. Go to Finisher Interlocks. Check the wires between the Finisher PWB, the Eject Cover Switch and the Finisher Front Door Switch for an open circuit or poor contact. If the wires are good, replace the Front Door Interlock Switch. Select Stop. Check the following: • Alignment between the Front Door and the Front Door Interlock Switch • Front Door and Front Cover for proper installation • Actuator for damage or bent • Magnet for proper mounting If the above checks are OK, replace the Finisher Main PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie