Description: Stapler NG. The Staple Home Sensor has not switched from Off to On within the specified time after the Staple Motor started rotating forward. The Staple Head Home Sensor turned On within xxx msec. after the Staple Motor reversed.
Remedy: • The Actuator for deformation • The Staple Home Sensor for improper installation • The Staple Home Sensor connectors for connection failure • The Staple Guide for a foreign substance and deformation • The Staple Motor for operation failure • The Staple Motor connectors for connection failure Enter dc330 Component Control [012-046] and [012-047], Staple Motor (PL 24.33 Item 9), alternately. Select Start. The Staple Motor energizes. Y↓ N→Select Stop. Go to Finisher Stapler Control. Check continuity between the Stapler Assembly and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Stapler Assembly. If the problem continues, replace the Finisher Main PWB. Select Stop. Select [012-244], Staple Home Sensor, (part of Stapler Assembly) (PL 24.33). Select [012-046] and [012-047], Staple Motor (PL 24.33), alternately. Select Start. The display changes. Y↓ N→Select Stop. Go to Finisher Stapler Control. Check continuity between the Stapler and Finisher PWB. The continuity check is OK. Y↓ N→Repair the open circuit or short circuit. Replace the Stapler Assembly. If the problem continues, replace the Finisher Main PWB. Select Stop. If the problem continues, replace the Finisher Main PWB.