Code: 312.959
Description: Full Stack Detected. Stacker No Paper Sensor On was detected during the Stacker Tray height adjusting operation.
Remedy: • The Stacker No Paper Sensor for improper installation • The Stacker No Paper Sensor connectors for connection failure • The Elevator Motor for operation failure • The Elevator Motor connectors for connection failure
Enter dc330 Component Control [012-061] Elevator Motor Down and [012-060] Elevator Motor UP (PL 24.31), alternately. Select Start. The Elevator Motor energizes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Elevator Motor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Elevator Motor (PL 24.31 Item 26). If the problem continues, replace the Finisher PWB Select Stop. Select [012-262], Stacker No Paper Sensor (PL 24.31 Item 32). Select Start. Block/unblock the Stacker No Paper Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Stacker No Paper Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Stacker No Paper Sensor. If the problem continues, replace the Finisher PWB Select [012-263], Stacker Encoder Sensor (PL 24.31 Item 32). Select Start. Block/unblock the Stacker Encoder Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive Check continuity between the Stacker Encoder Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Stacker Encoder Sensor. If the problem continues, replace the Finisher PWB Select Stop. If the problem continues, replace the Finisher Main PWB.
Enter dc330 Component Control [012-061] Elevator Motor Down and [012-060] Elevator Motor UP (PL 24.31), alternately. Select Start. The Elevator Motor energizes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Elevator Motor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Elevator Motor (PL 24.31 Item 26). If the problem continues, replace the Finisher PWB Select Stop. Select [012-262], Stacker No Paper Sensor (PL 24.31 Item 32). Select Start. Block/unblock the Stacker No Paper Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive. Check continuity between the Stacker No Paper Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Stacker No Paper Sensor. If the problem continues, replace the Finisher PWB Select [012-263], Stacker Encoder Sensor (PL 24.31 Item 32). Select Start. Block/unblock the Stacker Encoder Sensor. The display changes. Y↓ N→Select Stop. Go to Finisher Stacker Drive Check continuity between the Stacker Encoder Sensor and Finisher PWB. The continuity check is OK, Y↓ N→Repair the open circuit or short circuit. Replace the Stacker Encoder Sensor. If the problem continues, replace the Finisher PWB Select Stop. If the problem continues, replace the Finisher Main PWB.