Remedy: Execute dc330 Component Control [013-143], Booklet Staple Move Home Sensor. Move the Booklet Staplers to block and unblock the Sensor (PL 23.18 Item 13). The display changes. Y↓ N→Check the wire between J8897 pin 2 and P/J8991 pin 2 for an open or short circuit, or a loose or damaged connector. The wire is OK. Y↓ N→Repair/reconnect as required. Measure the voltage between P/J8991, pins 3 and 1 on the Booklet PWB (Booklet Staple Positioning). The voltage is approx. +5VDC. Y↓ N→Replace the Booklet PWB. Measure the voltage between P/J8991 pin 2 on the Booklet PWB and GND (Booklet Staple Positioning. Actuate the Booklet Staple Move Home Sensor. The voltage changes. Y↓ N→Replace the Booklet Staple Move Home Sensor (PL 23.18 Item 13). Replace the Booklet PWB. Alternately execute dc330 Component Control [013-028], Stapler Move Motor In and [013- 029], Stapler Move Motor Out. The Stapler Move Motor moves. Y↓ N→Check the wires between P/J8992 pins 1~6 on the Booklet PWB and P/J8906 on the Booklet Stapler Move Motor Booklet Staple Positioning for an open or short circuit, or loose or damaged connectors. The wires are OK. Y↓ N→Repair/replace as required. Monitor the voltage at P/J8994, pin 3 (Booklet Staple Positioning). Alternately execute dc330 Component Control [013-028], Stapler Move Motor In and [013-029], Stapler Move Motor Out. An AC clock pulse is detected. Y↓ N→Check the wire between P/J8994, pin 3 and P/J8995 pin 4. If the wire is OK, replace the Finisher PWB. Replace the Booklet Stapler Move Motor. If the problem persists, replace the Booklet PWB.