Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 347.211 — Xerox Phaser 7800

Code: 347.211

Description: Exit 1 OCT Home Fault. After the Exit 1 OCT Motor has ran for the specified operation time, the Exit 1 OCT Home Position Sensor does not turn On
Remedy: Turn the power On and enter Service Diagnostics (Entering Service Diagnostics). Turn On dc330 Component Control [077-109]. Move the OCT Chute manually to block/clear the light path to the Exit 1 OCT Home Position Sensor. Does the display change between High/Low? Y↓ N→Use Reflective Sensor RAP to check the Exit 1 OCT Home Position Sensor. Press the Stop button. Turn On dc330 Component Control [077-040] and dc330 Component Control [077-041] alternately. Does the OCT 1 Chute move forward and backward? Y↓ N→Is the voltage between the MD PWB P/J524-3/4 (+) and the GND (-) +24VDC? Y↓ N→Go to +24VDC Power RAP. Turn the power Off and check the Exit 1 OCT Motor Gear for blockage and the OCT Chute for damage. Also, check the connection between the MD PWB P/J524 and the Exit 1 OCT Motor P/J271 for open circuit, short circuit, and poor contact. If no problems are found, replace the following parts in sequence: • Exit 1 OCT Motor (PL 17.2 Item 4) • MD PWB Press the Stop button and turn the power Off. Replace the MD PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie