Description: Reg Sensor On Jam (Tray2/3/4/5). The Reg Sensor does not turn On within the specified time after the Reg Clutch On after the Feed from the Tray has started.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • The Tray 2 Feed Roll, Retard Roll, and Nudger Roll for contamination, wear, and revolution failure (when the jam has occurred during Feed from Tray 2) • Each Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure • Each Takeaway Roll Drive Gear for wear and damage • Use of paper out of spec (refer to Media and Tray Specifications). • The Reg Sensor for contamination, improper installation, and Actuator operation failure • The Reg Sensor for failure: dc330 Component Control [077-103] (PL 15.2) • The connection between the Reg Sensor P/J160 and the MD PWB P/J523 for open circuit, short circuit, and poor contact • The Main Drive Motor for revolution failure: dc330 Component Control [042-002] (PL 3.2) • The Tray 2 Feed/Lift Up Motor for revolution failure: dc330 Component Control [071-001] (PL 9.4) (when the jam has occurred during Feed from Tray 5) • The Takeaway Motor for revolution failure: dc330 Component Control [077-050] (PL 15.1) • The TM Takeaway Motor for revolution failure: dc330 Component Control [077-035] (PL 10.9) • The TM Takeaway Motor 2 for revolution failure): dc330 Component Control [077-037] (PL 10.9) If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB