Description: Tray 2 Lift Up Fault. Tray 2 Lift Up NG has occurred 3 times in a row.
Remedy: Remove Tray 2. Turn the power On and enter the Diag mode. Turn On dc330 Component Control [071-001] (Tray 2 Feed/Lift Up Motor). Does the Tray 1 Feed/Lift Up Motor rotate? Y↓ N→Is the voltage between the MD PWB P/J520-9 (+) and the GND (-) +24VDC? Y↓ N→Go to +24VDC Power RAP. Turn the power Off, then measure the Tray 5 Feed/Lift Up Motor wire wound resistance. Remove the Rear Upper Cover, then measure the following resistances. • Between the MD PWB P/J528-B1 and the P/J528-B2 • Between the MD PWB P/J528-B3 and the P/J528-B4 Is the resistance approx. 4.0 Ohm for each? (At 25° C / 77° F) Y↓ N→Check the connection between the MD PWB P/J528 and the Tray 2 Feed/Lift Up Motor P/J268 for open circuit, short circuit, and poor contact. If there are no problems, replace the Tray 2 Feed/Lift Up Motor (PL 9.4). Measure the resistance between the MD PWB P/J528-B1/B2/B3/B4 and the Frame. Is the resistance infinite for all? Y↓ N→Check the wires of the pins with non-infinite resistance for peeled-off coatings and short circuits due to pinching. Replace the following parts in sequence: • MD PWB • MCU PWB Press the Stop button. Turn On dc330 Component Control [071-102] (Tray 2 Nudger Level Sensor). Use a sheet of paper, etc. to block/clear the light path to the Tray 2 Nudger Level Sensor. Does the display change between High/Low? Y↓ N→Use Permeable Sensor Failure RAP to check the Tray 1 Nudger Level Sensor. Press the Stop button and turn the power Off. Check the Tray Lift Up Gear for damage or the Tray Lift Up mechanism for mechanical load. If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB