Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 372.102 — Xerox Phaser 7800

Code: 372.102

Description: Feed Out Sensor 3 On Jam (Tray 3/4).
Remedy: The Tray 3/4 Feed Out Sensor does not turn On within the specified time after the Feed from Tray 3 or Tray 4 has started.
Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • The TM Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure • The TM Takeaway Roll Drive Gear for wear and damage • Use of paper out of spec (Refer to the spec in Chapter 6 General) • The Tray 3/4 Feed Out Sensor for contamination, improper installation, and Actuator operation failure • The Tray 3/4 Feed Out Sensor for failure: dc330 Component Control [072-103] (PL 10.12) • The connection between the Tray 3 Feed Out Sensor P/J108 and the Tray Module PWB P/549 for open circuit, short circuit, and poor contact • The TM Takeaway Motor for revolution failure: dc330 Component Control [077-035] (PL 10.9) • The connection between the MD PWB P592 and the Tray Module PWB P/J541 for open circuit, short circuit, and poor contact If no problems are found, replace the following parts in sequence: • Tray Module PWB • MD PWB • MCU PWB

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie