Description: Tray 4 Lift Up Fault. Tray 4 Lift Up NG has occurred 3 times in a row.
Remedy: Remove Tray 4. Turn the power On and enter the Service Diag mode (Entering Service Diagnostics). Turn On dc330 Component Control [073-001] (Tray 4 Feed/Lift Up Motor). Does the Tray 3 Feed/Lift Up Motor rotate? Y↓ N→Is the voltage between the Tray Module PWB P/J541-10 (+) and the GND (-) +24VDC? Y↓ N→Go to +24VDC Power RAP. Turn the power Off, then measure the Tray 4 Feed/Lift Up Motor wire wound resistance. Remove the Rear Upper Cover, then measure the following resistances. • Between the Tray Module PWB P/J550-5 and P/J550-6 • Between the Tray Module PWB P/J550-7 and P/J550-8 Is the resistance approx. 4.0 Ohm for each? (At 25° C / 77° F) Y↓ N→Check the connection between the Tray Module PWB P/J550 and the Tray 4 Feed/ Lift Up Motor P/J222 for open circuit, short circuit, and poor contact. If there are no problems, replace the Tray 4 Feed/Lift Up Motor (PL 10.3 Item 3). Measure the resistance between the Tray Module PWB P/J550-5/6/7/8 and the Frame. Is the resistance infinite for all? Y↓ N→Check the wires of the pins with non-infinite resistance for peeled-off coatings and short circuits due to pinching. Replace the following parts in sequence: • Tray Module PWB • MD PWB • MCU PWB Press the Stop button. Turn On DC330 [073-102] (Tray 4 Nudger Level Sensor). Use a sheet of paper, etc. to block/clear the light path to the Tray 4 Nudger Level Sensor. Does the display change between High/Low? Y↓ N→Use Transmissive Sensor RAP to check the Tray 4 Nudger Level Sensor. Press the Stop button and turn the power Off. Check the Tray Lift Up Gear for damage or the Tray Lift Up mechanism for mechanical load. If no problems are found, replace the following parts in sequence: • Tray Module PWB • MD PWB • MCU PWB