Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 375.100 — Xerox Phaser 7800

Code: 375.100

Description: Tray 1 Miss Feed. The Tray 1 Feed Out Sensor does not turn On within the specified time after the Feed from Tray 5 has started.
Remedy: Turn the power On and enter the Service Diag mode (Entering Service Diagnostics). Turn On dc330 Component Control [075-001] (Tray 1 Feed/Nudger Motor). Does the Tray 1 Feed/ Nudger Motor rotate? Y↓ N→Is the voltage between the MD PWB P/J520-1 (+) and the GND (-) +24VDC? Y↓ N→Go to +24VDC Power RAP. Turn the power Off, then measure the Tray 1 Feed/Nudger Motor wire wound resistance. Check the resistance of the following. • Between the MD PWB P/J525-B10 and the P/J525-B11 • Between the MD PWB P/J525-B12 and the P/J525-B13 Is the resistance approx. 4.0 Ohm for each? (At 25° C / 77° F) Y↓ N→Check the connection between the MD PWB P/J525 and Tray 1 Feed/Nudger Motor P/J269 for open circuit, short circuit, and poor contact. If no problems are found, replace the Tray 1 Feed/Nudger Motor (PL 13.2). Measure the resistance between the MD PWB P/J525-B10/B11/B12/B13 and the Frame. Is the resistance infinite for all? Y↓ N→Check the wires of the pins with non-infinite resistance for peeled-off coatings and short circuits due to pinching. Replace the following parts in sequence: • MD PWB • MCU PWB Press the Stop button. Turn On DC330 [077-104] (Tray 1 Feed Out Sensor). Activate the Actuator by using a sheet of paper, etc. to block/clear the light path to the Tray 1 Feed Out Sensor. Does the display change between High/Low? Y↓ N→Use Transmissive Sensor RAP to check the Tray 1 Feed Out Sensor. Press the Stop button and turn the power Off. Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • The Front Chute Floating Snap for disengagement • The Tray 1 Nudger Roll and Retard Spring for deformation and snags • The Tray 1 Feed Roll and Nudger Roll for contamination, wear, and revolution failure • The Tray 1 Feed Roll and Nudger Roll Drive Gears for wear and damage • Use of paper out of spec (refer to the Media and Tray Specifications). If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie