Description: Tray 1 Feed Out Sensor Off Jam. The Tray 1 Feed Out Sensor does not turn Off within the specified time after the Reg Clutch On.
Remedy: Check the following: • A paper transportation failure due to foreign substances/burrs on the paper path and deformed paper guides • The Tray 1 Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure • The Reg Roll and Pinch Roll for contamination, wear, and revolution failure • The 2nd BTR for contamination, wear, and revolution failure • The Tray 1 Takeaway Roll Drive Gear for wear and damage • The Reg Roll Drive Gear for wear and damage • The 2nd BTR Contact Retract Drive Gear for wear or damage • The Fuser Drive Gear for wear and damage • Use of paper out of spec (refer to the Media and Tray Specifications). • The Tray 1 Feed Out Sensor for contamination, improper installation, and Actuator operation failure • The Tray 1 Feed Out Sensor for failure: dc330 Component Control [077-104] (PL 13.4) • The connection between the Tray 1 Feed Out Sensor P/J179 and the MD PWB P/J525 for open circuit, short circuit, and poor contact • The Main Drive Motor for revolution failure: DC330 [042-002] (PL 3.2) • The 2nd BTR Contact Retract Motor for revolution failure: DC330 [094-003] (Contact), DC330 [094-004] (Retract) (PL 14.4) • The Fuser Drive Motor for revolution failure: DC330 [010-006] (PL 3.1) • The Takeaway Motor for revolution failure: DC330 [077-050] (PL 15.1) • The Reg Clutch for failure: DC330 [077-002] (PL 15.2) If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB