Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 377.103 — Xerox Phaser 7800

Code: 377.103

Description: Exit Sensor 1 Off Jam. After the Fuser Exit Sensor turned On, the Fuser Exit Sensor did not turn Off within the specified time.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • The Fuser for wound up, stuck paper • Each Exit Roll and Pinch Roll for contamination, wear, and revolution failure • Each Exit Roll Drive Gear for wear and damage • The Exit 1 Gate for operation failure • The Exit 2 Gate for operation failure • Use of paper out of spec (refer to the Media and Tray Specifications). • The Fuser Exit Sensor for contamination, improper installation, and Actuator operation failure • The Fuser Exit Sensor for failure: dc330 Component Control [077-101] (PL 7.1) • The connection between the Fuser Assembly DJ600 and the MCU PWB P/J431 for open circuit, short circuit, and poor contact • The Fuser Drive Motor for revolution failure: DC330 [010-006] (PL 3.1) • The Exit 2 Drive Motor for revolution failure: DC330 [077-060] (PL 17.4) • The Exit 2 Gate Solenoid for failure: DC330 [077-003] (PL 17.5) • The Face Up Gate Solenoid for failure: DC330 [077-004] (PL 17.5) If no problems are found, replace the following parts in sequence: • MCU PWB • MD PWB

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie