Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 377.105 — Xerox Phaser 7800

Code: 377.105

Description: Exit Sensor 2 Off Jam. After the Exit 2 Sensor turned On, the Exit 2 Sensor did not turn Off within the specified time.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • The Exit 2 Roll and Pinch Roll for contamination, wear, and revolution failure • The Face Up Exit Roll and Pinch Roll for contamination, wear, and revolution failure • The Exit 2 Roll Drive Gear for wear and damage • The Exit 2 Gate for operation failure • The Face Up Exit Roll Drive Gear for wear and damage • Use of paper out of spec (refer to the Media and Tray Specifications). • The Exit 2 Sensor for contamination, improper installation, and Actuator operation failure • The Exit 2 Sensor for failure: dc330 Component Control [077-100] (PL 17.4) • The connection between the Exit 2 Sensor P/J164 and the MD PWB P/J522 for open circuit, short circuit, and poor contact • The Exit 2 Drive Motor for revolution failure: DC330 [077-060] (PL 17.4) • The Face Up Gate Solenoid for failure: DC330 [077-004] (PL 17.5) If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie