Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 377.106 — Xerox Phaser 7800

Code: 377.106

Description: Exit Sensor 1 On Jam. The Fuser Exit Sensor does not turn On within the specified time after the Reg Clutch On.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • Each Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure • The Reg Roll and Pinch Roll for contamination, wear, and revolution failure • The 2nd BTR for contamination, wear, and revolution failure • The Fuser for wound up, stuck paper • Each Takeaway Roll Drive Gear for wear and damage • The Reg Roll Drive Gear for wear and damage • The 2nd BTR Contact Retract Drive Gear for wear or damage • The Fuser Drive Gear for wear and damage • Use of paper out of spec (refer to the Media and Tray Specifications). • The Fuser Exit Sensor for contamination, improper installation, and Actuator operation failure • The Fuser Exit Sensor for failure: dc330 Component Control [077-101] (PL 7.1) • The connection between the Fuser Assembly DJ600 and the MCU PWB P/J431 for open circuit, short circuit, and poor contact • The Main Drive Motor for revolution failure: DC330 [042-002] (PL 3.2) • The 2nd BTR Contact Retract Motor for revolution failure: DC330 [094-003] (Contact), DC330 [094-004] (Retract) (PL 14.4) • The Fuser Drive Motor for revolution failure: DC330 [010-006] (PL 3.1) • The Takeaway Motor for revolution failure: DC330 [077-050] (PL 15.1) • The Reg Clutch for failure: DC330 [077-002] (PL 15.2) If no problems are found, replace the following parts in sequence: • MCU PWB • MD PWB

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie