Description: POB Sensor On Jam. The POB Sensor does not turn On within the specified time after the Reg Clutch On.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • Each Takeaway Roll and Pinch Roll for contamination, wear, and revolution failure • The Reg Roll and Pinch Roll for contamination, wear, and revolution failure • The 2nd BTR for contamination, wear, and revolution failure • The Transfer Belt for wound up, stuck paper • Each Takeaway Roll Drive Gear for wear and damage • The Reg Roll Drive Gear for wear and damage • The 2nd BTR Contact Retract Drive Gear for wear or damage • Use of paper out of spec (refer to the Media and Tray Specifications). • The POB Sensor for contamination and improper installation • The POB Sensor for failure: dc330 Component Control [077-102] (PL 14.4) • The connection between the POB Sensor P/J180 and the MD PWB P/J523 for open circuit, short circuit, and poor contact • The Main Drive Motor for revolution failure: DC330 [042-002] (PL 3.2) • The 2nd BTR Contact Retract Motor for revolution failure: DC330 [094-003] (Contact), DC330 [094-004] (Retract) (PL 14.4) • The Takeaway Motor for revolution failure): DC330 [077-050] (PL 15.1) • The Regret Clutch for failure: DC330 [077-002] (PL 15.2) If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB