Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 377.130 — Xerox Phaser 7800

Code: 377.130

Description: Reg Sensor On Jam (Duplex Direct). The Reg Sensor does not turn On within the specified time after the Reg Clutch On after the Feed has started in Duplex Direct mode.
Remedy: Check the following: • A paper transportation failure due to a foreign substance/burr on the paper path • Each Duplex Roll and Pinch Roll for contamination, wear, and revolution failure • Each Duplex Roll Drive Gear for wear and damage • Use of paper out of spec (refer to the Media and Tray Specifications). • The Reg Sensor for contamination, improper installation, and Actuator operation failure • The Reg Sensor for failure: dc330 Component Control [077-103] (PL 15.2) • The connection between the Reg Sensor P/J160 and the MD PWB P/J523 for open circuit, short circuit, and poor contact • The Duplex Motor for revolution failure: DC330 [077-073] (PL 14.5) If no problems are found, replace the following parts in sequence: • MD PWB • MCU PWB

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie