Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 394.320 — Xerox Phaser 7800

Code: 394.320

Description: 1st BTR Contact/Retract Fault. After the 1st BTR Contact/Retract operation has started, it does not complete within the specified time.
Remedy: Remove the 1st BTR Contact Retract Sensor Bracket. Turn the power On and enter Service Diag mode (Entering Service Diagnostics). Turn On dc330 Component Control [094-200]. Use a sheet of paper, etc. to block/clear the light path to the 1st BTR Contact Retract Sensor. Does the display change between High/Low? Y↓ N→Use Transmissive Sensor RAP to fix the 1st BTR Contact Retract Sensor. Press the Stop button and turn the power Off. Install the 1st BTR Contact Retract Sensor Bracket. Turn the power ON and enter Service Diag mode. Turn On dc330 Component Control [094- 012] (Contact) and DC330 [094-013] (Retract) alternately. Does it contact/retract? Y↓ N→Remove the IBT and check the following: • The IBT Assembly for mechanical loading or damage • The 1st BTR Contact Retract Gear for wear, damage, and operation failure • The 1st BTR Contact Retract Clutch for improper installation • The 1st BTR Contact Retract Sensor for improper installation • The connection between the 1st BTR Contact Retract Clutch P/J250 and the MCU PWB P/J417 for open circuit, short circuit, and poor contact If no problems are found, replace the 1st BTR Contact Retract Clutch (PL 3.2). Press the Stop button and turn the power Off. Replace the MCU PWB.

← Xem tất cả mã lỗi Xerox Phaser 7800

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie