Code: 2,00X.xx
Description: I/O Board Errors The following troubleshooting procedure applies to these errors: 2,001.47 The Print Engine does not detect the I/O Board
Causes: I/O Board, PL 5.0 Right Side Harness / I/O Control - Right Side Harness, PL 5.0 Right Side Wire Routing (1/2) - I/O Board Power Control Cable, PL 5.0 Right Side Wire Routing (1/2) -
Remedy: • Check the I/O Board for obvious signs of damage. • Check that all connections to the board are secure by reseating each connection. • If the problem persists, follow the procedure below.
1 Check the I/O Board for damage. Are the connectors damaged? Repair the damaged connections. Go to Step 2. 2 Reseat all I/O Board connections. Does the problem persist? Go to Step 3. Complete. 3 Check I/O Power Control Cable continuity between P/J840 on the I/O Board and P/ J10 on the Electronics Module. Is the wiring defective? Replace the cable. If the error persists, replace the I/O Board. Replace the I/O Board
1 Check the I/O Board for damage. Are the connectors damaged? Repair the damaged connections. Go to Step 2. 2 Reseat all I/O Board connections. Does the problem persist? Go to Step 3. Complete. 3 Check I/O Power Control Cable continuity between P/J840 on the I/O Board and P/ J10 on the Electronics Module. Is the wiring defective? Replace the cable. If the error persists, replace the I/O Board. Replace the I/O Board