Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 4,0xx.4x — Xerox Phaser 8400

Code: 4,0xx.4x

Description: Process Control Errors. The following troubleshooting procedure applies to these errors: 4,017.47 The ambient temperature is too low ( < 10°C). 4,018.48 The Printhead temperature is too low. 4,020.41 Fast Time To Ready (FTTR) mode with head/cap flag set in NVRAM. 4,021.42 Fast Time To Ready (FTTR) mode with a dirty Drum.
Causes: Electronics Module, PL 5.0 Right Side Wire Routing (2/2) - Printhead, PL 2.0 Electronics Module - Drum Assembly, PL 2.0 Electronics Module Power - Drum Heater Relay Board, PL 5.0 Right Side Wire Routing (1/2) - Drum Temperature Sensor, PL 6.0 I/O Board (2/2) -
Remedy: • Check the ambient air temperature. • Check that the system is located in a suitable environment. • If the problem persists, follow the procedure below.
1 Test the heaters. Run the Service Diagnostics Monitor Heaters tests with all heaters On. Do the heaters function properly? Replace the Electronics Module. Go to Step 3. 2 Check the harness to the failed heater. Is the harness damaged? Replace the harness. Replace the failed component.

← Xem tất cả mã lỗi Xerox Phaser 8400

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie