Code: 33,00X.4x
Description: Tray 1 Width Sensor Faults The Paper Width Sensor, located in the Tray 1/Front Door Assembly is reporting out of range values. The following troubleshooting procedure applies to these errors: 33,001.42 Tray 1 width value too low. 33,002.43 Tray 1 width value too high.
Causes: Tray 1/Front Door Assembly, PL 1.0 I/O Board (2/2) -
Remedy: • Check electrical connection to Tray 1 (P/J650). • Check for obstructions or damage to the Media Guides. • If the problem persists, follow the procedure below.
1 Check the Tray 1 Harness connection to the I/O Board (P/J610). Is the connection secure and the harness undamaged? Go to Step 2. Repair or replace the harness. 2 Test the Width Sensors. Run the Service Diagnostics Tray 1 Width Sensor test. Does the sensor operate correctly? Replace the I/O Board. Replace the Tray 1/ Front Door Assembly.
1 Check the Tray 1 Harness connection to the I/O Board (P/J610). Is the connection secure and the harness undamaged? Go to Step 2. Repair or replace the harness. 2 Test the Width Sensors. Run the Service Diagnostics Tray 1 Width Sensor test. Does the sensor operate correctly? Replace the I/O Board. Replace the Tray 1/ Front Door Assembly.