Code: 37,0XX.xx
Description: PEST Heater Faults An heating error has occurred. The following troubleshooting procedure applies to these errors: 37,001.46 An error occurred during PEST execution. 37,002.47 The Left Jetstack is drawing less power than expected. 37,003.48 The Right Jetstack is drawing less power than expected. 37,004.40 Ink Reservoir 0 is drawing less power than expected. 37,005.41 Ink Reservoir 1 is drawing less power than expected. 37,006.42 The Drum Heater is drawing less power than expected. 37,008.44 The Preheater is drawing less power than expected. 37,009.45 All Ink Melt Heaters are drawing less power than expected. 37,010.46 The Yellow (0) Ink Melt Heater is drawing less power than expected. 37,011.44 The Cyan (1) Ink Melt Heater is drawing less power than expected. 37,012.48 The Magenta (2) Ink Melt Heater is drawing less power than expected. 37,013.48 The Black (3) Ink Melt Heater is drawing less power than expected.
Causes: Ink Loader Assy, PL 2.0 Electronics Module - Printhead, PL 2.0 Electronics Module - Preheater, PL 2.0 Electronics Module Power -
Remedy: • Check the Printhead, Preheater and Ink Loader power connections. • If the problem persists, follow the procedure below.
1 Test the affected component. Run the Service Diagnostics test for the affected component. Does the affected component reach operating temperature? Go to Step 2. Replace the affected component. 2 Check wiring to the affected component. Is the wiring damaged? Repair or replace the harness. Replace the affected component.
1 Test the affected component. Run the Service Diagnostics test for the affected component. Does the affected component reach operating temperature? Go to Step 2. Replace the affected component. 2 Check wiring to the affected component. Is the wiring damaged? Repair or replace the harness. Replace the affected component.