Code: T2A ... T2Z
Description: T2A T2B T2C T2D T2E T2F T2G T2H T2J T2K T2L T2M T2N T2P T2Q T2R T2S T2T T2X T2Z Exit Door Interlock tripped following an abnormal shutdown. Exit Door Interlock tripped following a normal shutdown. Exit Door Interlock tripped during mechanical recovery Exit Door Interlock tripped during warm-up. Exit Door Interlock tripped during ready state. Exit Door Interlock tripped during a fault state. Exit Door Interlock tripped during an auto drum maintenance cycle. Exit Door Interlock tripped during Printhead maintenance. Exit Door Interlock tripped during Printhead purge. Exit Door Interlock tripped during an oil Transfix Roller cycle. Exit Door Interlock tripped during standby mode. Exit Door Interlock tripped during pick from Tray 2. Exit Door Interlock tripped during pick from Tray 3. Exit Door Interlock tripped during pick from Tray 4. Exit Door Interlock tripped during pick from Tray 1. Exit Door Interlock tripped during duplexing. Exit Door Interlock tripped during transfix staging. Exit Door Interlock tripped during transfixing. Exit Door Interlock tripped during paper exit. Exit Door Interlock tripped during shutdown.
Causes:
Remedy: 1. Check for supported media. 2. Check system grounds. 3. Run the Monitor Sensors test using Service Diagnostics. 4. Check the Exit Door Interlock Switch. Replace if necessary. 5. Check the Drum Maintenance Kit is functioning properly and the blade is not covered with ink debris. Replace if necessary 6. Replace the Transfix Roller.