Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 1,00X.4x — Xerox Phaser 8510 MFP

Code: 1,00X.4x

Description: 525-Sheet Feeder Faults The following troubleshooting procedure applies to these errors: 1,001.46 An over current condition was detected in the upper 525-Sheet Feeder. The lift motor or clutch may be shorted. 1,002.47 An over current condition was detected in the lower 525-Sheet Feeder. The lift motor or clutch may be shorted.
Causes: Tray Feeder, PL 3.0 Pick Assy and Retard Roller Kit, PL 3.0 Left Side Harness, PL 5.0
Remedy: • Check the tray to ensure it is free of obstructions or debris. • Check the operation of the Tray Lift Plate. • Check the condition of the Feed and Pick Rollers. • Reseat the optional tray connection to the system. • If the problem persists, follow the procedure below.
1 Remove the 525-Sheet Feeder and check the connections for damage. Are the connectors damaged? Replace the damaged connections. Go to Step 2. 2 Check the Pick Assembly for dirt, damage, or wear. Are the rollers damaged or worn? Replace the Pick Assembly. 3 Test the Pick Clutch. Run the Service Diagnostics Pick Clutch test for the affected tray. Does the Pick Clutch operate correctly? Go to Step 3. Replace the feeder. 4 Test the Lift Motor. Run the Service Diagnostics Lift Motor test for the affected tray. Does the Lift Motor operate correctly? 5 Check the wiring from the feeder to Electronics Module. Is the wiring defective? Replace the harness. If the error persists, go to Step 6. Replace the feeder. 6 Check ground integrity. Are the system grounds connected? Reset NVRAM. If the error persists, replace the feeder. Reconnect the system grounds.

← Xem tất cả mã lỗi Xerox Phaser 8510 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie