Code: 19,0XX.6x
Description: Waveform Program Faults A software error has occurred. The following troubleshooting procedure applies to these errors: 19,001.68 to 19,039.61 Waveform Printhead calibration program faults.
Causes: NVRAM, PL 5.0
Remedy: • Reset NVRAM and retest. • If the problem persists, follow the procedure below.
1 Reseat all Electronics Module connections. Does the problem persist? Go to Step 2. Complete. 2 Check ground integrity. Check that the ground straps are place between the Media Drive Motor and YAxis Assembly. Also check the ground clip at the Tray 2 Pick Clutch. Are the system grounds connected? Reset NVRAM. If the error persists, replace the NVRAM device. Reconnect the system grounds.
1 Reseat all Electronics Module connections. Does the problem persist? Go to Step 2. Complete. 2 Check ground integrity. Check that the ground straps are place between the Media Drive Motor and YAxis Assembly. Also check the ground clip at the Tray 2 Pick Clutch. Are the system grounds connected? Reset NVRAM. If the error persists, replace the NVRAM device. Reconnect the system grounds.