Code: 37,0XX.4x
Description: PEST Power Supply Faults An Power Supply error has occurred. The following troubleshooting procedure applies to these errors: 37,041.41 The Power Supply failed to reset. 37,043.43 The Power Supply 2.5 V source over limit. 37,044.44 The Power Supply 2.5 V source under limit. 37,045.45 The Power Supply 3.3 V source over limit. 37,046.46 The Power Supply 3.3 V source under limit. 37,047.47 The Power Supply 12 V source over limit. 37,048.48 The Power Supply 12 V source under limit. 37,049.40 The Power Supply -12 V source over limit. 37,050.41 The Power Supply -12 V source under limit. 37,051.42 The Power Supply current over limit. 37,052.43 The Power Supply current under limit. 37,053.44 The Power Supply 50 V source over limit. 37,054.45 The Power Supply 50 V source under limit. 37,055.46 The Power Supply -50 V source over limit. 37,056.47 The Power Supply -50 V source under limit. 37,057.48 The Power Supply 15 V source over limit. 37,058.40 The Power Supply 15 V source under limit. 37,059.41 The Power Supply -15 V source over limit. 37,060.42 The Power Supply -15 V source under limit. 37,061.43 The Power Supply 5 V source over limit. 37,062.44 The Power Supply 5 V source under limit. 37,063.45 The Power Supply high switch not activated. Electrical short or missing reset line. 37,064.46 Vss too low. The Printhead power harness may be disconnected. 37,065.47 Vpp too low. The Printhead or Wave Amp may be disconnected. 37,066.48 The Wave Amplifier s drawing too much power. Possible short.
Causes: Electronics Module, PL 5.0
Remedy: • Check the component power connections and harness condition. • If the problem persists, follow the procedure below.
1 Test the Power Supply. Run the Service Diagnostics Voltages test. Does the Power Supply operate correctly? Go to Step 2. Replace the Electronics Module. 2 Check the Printhead Power connection. Is the wiring disconnected or damaged? Repair or replace the harness. Replace the Electronics Module.
1 Test the Power Supply. Run the Service Diagnostics Voltages test. Does the Power Supply operate correctly? Go to Step 2. Replace the Electronics Module. 2 Check the Printhead Power connection. Is the wiring disconnected or damaged? Repair or replace the harness. Replace the Electronics Module.