Code: 7,007.49
Description: Process Drive Fault A Process Drive or Printhead error has occurred. The following troubleshooting procedures applies to this error: 7,007.49 The Process Drive stalled while tilting the Printhead.
Causes: Process Drive, PL 4.0 Right Side Harness / I/O Control -
Remedy: • Check that the Process Drive gear train is properly homed. • Check for obstructions or ink spills around the Printhead. • Verify the Printhead travels smoothly from left to right. • Check the Printhead Restraint Arms. • If the problem persists, follow the procedure below.
1 Check that the Process Drive is properly aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 2. 2 Remove the Printhead and inspect the Head Tilt Gear, Spring, and Process Drive gears for ink spills. Clean if necessary. Does the error persist? Go to Step 3. Complete. 3 Realign the Process Drive (ADJ 4.7.1). Does the error persist? Replace the Process Drive. Complete.
1 Check that the Process Drive is properly aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 2. 2 Remove the Printhead and inspect the Head Tilt Gear, Spring, and Process Drive gears for ink spills. Clean if necessary. Does the error persist? Go to Step 3. Complete. 3 Realign the Process Drive (ADJ 4.7.1). Does the error persist? Replace the Process Drive. Complete.