Code: 1,00X.4x
Description: 525-Sheet Feeder Faults The following troubleshooting procedure applies to these errors: 1,001.46 An over current condition was detected in the upper 525-Sheet Feeder. The lift motor or clutch may be shorted. 1,002.47 An over current condition was detected in the lower 525-Sheet Feeder. The lift motor or clutch may be shorted.
Causes: Tray Feeder, PL 3.0 Pick Assy and Retard Roller Kit, PL 3.0 Left Side Harness, PL 5.0
Remedy: • Check the tray to ensure it is free of obstructions or debris. • Check the operation of the Tray Lift Plate. • Check the condition of the Feed and Pick Rollers. • Reseat the optional tray connection to the system. • If the problem persists, follow the procedure below.
1 Remove the 525-Sheet Feeder and check the connections for damage. Are the connectors damaged? Replace the damaged connections. Go to Step 2. 2 Check the Pick Assembly for dirt, damage, or wear. Are the rollers damaged or worn? Replace the Pick Assembly. 3 Test the Pick Clutch. Run the Service Diagnostics Pick Clutch test for the affected tray. Does the Pick Clutch operate correctly? Go to Step 3. Replace the feeder. 4 Test the Lift Motor. Run the Service Diagnostics Lift Motor test for the affected tray. Does the Lift Motor operate correctly? 5 Check the wiring from the feeder to Electronics Module. Is the wiring defective? Replace the harness. If the error persists, go to Step 6. Replace the feeder. 6 Check ground integrity. Are the system grounds connected? Reset NVRAM. If the error persists, replace the feeder. Reconnect the system grounds.
1 Remove the 525-Sheet Feeder and check the connections for damage. Are the connectors damaged? Replace the damaged connections. Go to Step 2. 2 Check the Pick Assembly for dirt, damage, or wear. Are the rollers damaged or worn? Replace the Pick Assembly. 3 Test the Pick Clutch. Run the Service Diagnostics Pick Clutch test for the affected tray. Does the Pick Clutch operate correctly? Go to Step 3. Replace the feeder. 4 Test the Lift Motor. Run the Service Diagnostics Lift Motor test for the affected tray. Does the Lift Motor operate correctly? 5 Check the wiring from the feeder to Electronics Module. Is the wiring defective? Replace the harness. If the error persists, go to Step 6. Replace the feeder. 6 Check ground integrity. Are the system grounds connected? Reset NVRAM. If the error persists, replace the feeder. Reconnect the system grounds.