Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 19,0XX.6x — Xerox Phaser 8550

Code: 19,0XX.6x

Description: Waveform Program Faults A software error has occurred. The following troubleshooting procedure applies to these errors: 19,001.68 to 19,039.61 Waveform Printhead calibration program faults.
Causes: NVRAM, PL 5.0
Remedy: • Reset NVRAM and retest. • If the problem persists, follow the procedure below.
1 Reseat all Electronics Module connections. Does the problem persist? Go to Step 2. Complete. 2 Check ground integrity. Check that the ground straps are place between the Media Drive Motor and YAxis Assembly. Also check the ground clip at the Tray 2 Pick Clutch. Are the system grounds connected? Reset NVRAM. If the error persists, replace the NVRAM device. Reconnect the system grounds.

← Xem tất cả mã lỗi Xerox Phaser 8550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie