Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 39,005.43 — Xerox Phaser 8550

Code: 39,005.43

Description: Scanner Missing Fault A Scanner was not detected. The following troubleshooting procedure applies to these errors: 39,005.43 The system did not detect the Scanner Assembly.
Causes: Scanner Assembly, PL 1.0 Scanner Power Supply, PL 5.0 Exit Module Control Board - DADF, PL 1.0 Exit Module Control Board, PL 5.0 Exit Module Control Board - Exit Roller Motor, PL 4.0 Exit Module Control Board - Elevator Motor, PL 4.0 Exit Module Control Board -
Remedy: • Reseat the Scanner connection to the Electronics Module. • If the problem persists, follow the procedure below.
1 Cycle system power and retest. Does this correct the problem? Complete. Go to Step 2. 2 Check the Scanner Power Supply status LED (see ). Is the Status LED blinking? Go to Step 3. Go to Step 5. 3 Remove the Output Tray and Side Covers. Disconnect the Elevator (P/J303) and Exit Roller (P/J309) motors. Does the Status LED stop blinking and remain On? Replace the defective motor or the Exit ModuleGo to Step 4. 4 With the Exit Module motors disconnected, disconnect the DADF from the Scanner. Does the Status LED stop blinking and remain On? Replace the DADF. Go to Step 5. 5 Is the Status LED Off? Replace the Scanner Power Supply. If the error persists, replace the Electronics Module. Go to Step 6. 6 Disconnect the Scanner Assembly from the Electronics Module. Does the Status LED light? Replace the Scanner Assembly. Replace the Exit Module Control Board. If the error persists, replace the Scanner Power Supply. If the Status LED remains Off, replace the Electronics Module.

← Xem tất cả mã lỗi Xerox Phaser 8550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie