Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 7,002.44 — Xerox Phaser 8550

Code: 7,002.44

Description: Process Drive Fault A Process Drive error has occurred. The following troubleshooting procedure applies to this error: 7,002.44 The Process Drive stalled during operation.
Causes: Process Drive, PL 4.0 Right Side Harness / I/O Control -
Remedy: • Check that the Process Drive gear train is properly homed. • Check for obstructions in or around the Process Drive gearbox. • If the problem persists, follow the procedure below.
1 Check that the Process Drive is properly aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 2. 2 Test the Tilt Axis Drive. Run the Service Diagnostics Tilt Axis Drive test. Did the test pass? Go to Step 3. Go to Step 4. 3 Check the Process Drive for damage, debris, or obstructions. Is there any damage? Replace the Process Drive. Go to Step 4. 4 Test the Process Drive Motor. Run the Service Diagnostics Process Motor Test. Did the test fail? Replace the Process Drive. Go to Step 5. 5 Test the Transfix Cams Run the Service Diagnostics Transfix Drive Slow test. Do the Transfix Cam operate correctly? Replace the Process Drive. Verify the transfix cams are not damaged. If the error persists, replace the Transfix Cam Shaft.

← Xem tất cả mã lỗi Xerox Phaser 8550

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie