Code: 7,008.41
Description: Printhead Tilt Fault A Process Drive or Printhead error has occurred. The following troubleshooting procedure applies to this error:
Causes: Process Drive, PL 4.0 Right Side Harness / I/O Control - Head Tilt Solenoid, PL 4.0 Left Side Harness (2/2) - Head Tilt Gear, PL 4.0
Remedy: • Check that the Process Drive gear train is properly homed. • Check for obstructions or ink spills around the Printhead. • If the problem persists, follow the procedure below.
1 Reboot the system. Does the error persist? Go to Step 2. Complete. 2 Check for Ink spills on or near the Head Tilt Gear. Clean and reboot the system. Does the error persist? Go to Step 3. Complete. 3 Check that the Printhead moves properly to the left and right. Does the Printhead move correctly? Go to Step 4. Remove any obstructions or replace any defective parts. 4 Realign the Process Drive (ADJ 4.7.1). Does the error persist? Go to Step 5. Complete. 5 Check the Process Drive for damage, debris, or obstructions. Is there any damage? Replace the Process Drive. Go to Step 6. 6 Test the Tilt Axis Drive. Run the Service Diagnostics Tilt Axis Drive test. Did the test pass? Go to Step 7. Replace the Process Drive. 7 Test the Head Maintenance Clutch. Run the Service Diagnostics Head Maintenance Wiper Clutch test. Does the clutch operate correctly? Go to Step 8. Replace the clutch. 8 Check the Printhead Wiper alignment. Is the Printhead Wiper properly aligned? Go to Step 9. Perform ADJ 2.5.1. 9 Test the Wiper Drive. Run the Service Diagnostics Wiper Drive test. Does the Wiper Drive operate correctly? Replace the Exit Module. Repair or replace the Wiper Drive.
1 Reboot the system. Does the error persist? Go to Step 2. Complete. 2 Check for Ink spills on or near the Head Tilt Gear. Clean and reboot the system. Does the error persist? Go to Step 3. Complete. 3 Check that the Printhead moves properly to the left and right. Does the Printhead move correctly? Go to Step 4. Remove any obstructions or replace any defective parts. 4 Realign the Process Drive (ADJ 4.7.1). Does the error persist? Go to Step 5. Complete. 5 Check the Process Drive for damage, debris, or obstructions. Is there any damage? Replace the Process Drive. Go to Step 6. 6 Test the Tilt Axis Drive. Run the Service Diagnostics Tilt Axis Drive test. Did the test pass? Go to Step 7. Replace the Process Drive. 7 Test the Head Maintenance Clutch. Run the Service Diagnostics Head Maintenance Wiper Clutch test. Does the clutch operate correctly? Go to Step 8. Replace the clutch. 8 Check the Printhead Wiper alignment. Is the Printhead Wiper properly aligned? Go to Step 9. Perform ADJ 2.5.1. 9 Test the Wiper Drive. Run the Service Diagnostics Wiper Drive test. Does the Wiper Drive operate correctly? Replace the Exit Module. Repair or replace the Wiper Drive.