Code: 4,025.46
Description: Drum Transfix Fault The following troubleshooting procedure applies to this error: 4,025.46 Drum Transfix does not reach home position.
Causes: Process Drive, PL 5.0 Right Side Harness / I/O Control - X-Axis Motor, PL 2.0 Right Side Harness / I/O Control - Head Tilt Solenoid, PL 5.0 Left Side Harness (2/2) -
Remedy: • Check for dirt, debris, or obstructions around the Printhead. • Check that the Waste Tray is correctly installed. • If the problem persists, follow the procedure below.
1 Check for ink build up in the Head Tilt drive, Waste Tray, or wires interfering with Printhead motion. Is the Printhead clear of obstructions? Go to Step 11. Clear any obstructions to Printhead movement. If the error persists, go to Step 2. 2 Check the Process Drive for damage. Ensure the gears are correctly aligned (see ADJ 4.7.1). Is the process gearbox damaged? Replace the Process Drive. Go to Step 3. 3 Check the X-Axis Motor connection (P/ J150). Run the Service Diagnostics X-Axis Motor test. Did the test fail? Replace the X-Axis Motor. Go to Step 4. 4 Test the Printhead Tilt Drive. Run the Service Diagnostics Tilt Drive test. Did the test fail? Replace the Process Drive.
1 Check for ink build up in the Head Tilt drive, Waste Tray, or wires interfering with Printhead motion. Is the Printhead clear of obstructions? Go to Step 11. Clear any obstructions to Printhead movement. If the error persists, go to Step 2. 2 Check the Process Drive for damage. Ensure the gears are correctly aligned (see ADJ 4.7.1). Is the process gearbox damaged? Replace the Process Drive. Go to Step 3. 3 Check the X-Axis Motor connection (P/ J150). Run the Service Diagnostics X-Axis Motor test. Did the test fail? Replace the X-Axis Motor. Go to Step 4. 4 Test the Printhead Tilt Drive. Run the Service Diagnostics Tilt Drive test. Did the test fail? Replace the Process Drive.