Code: 7,002.44
Description: Process Drive Fault A Process Drive error has occurred. The following troubleshooting procedure applies to this error: 7,002.44 The Process Drive stalled during operation.
Causes: Process Drive, PL 4.0 Right Side Harness / I/O Control -
Remedy: • Check that the Process Drive gear train is properly homed. • Check for obstructions in or around the Process Drive gearbox. • If the problem persists, follow the procedure below.
1 Check that the Process Drive is properly aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 2. 2 Test the Tilt Axis Drive. Run the Service Diagnostics Tilt Axis Drive test. Did the test pass? Go to Step 3. Go to Step 4. 3 Check the Process Drive for damage, debris, or obstructions. Is there any damage? Replace the Process Drive. Go to Step 4. 4 Test the Process Drive Motor. Run the Service Diagnostics Process Motor Test. Did the test fail? Replace the Process Drive. Go to Step 5. 5 Test the Transfix Cams Run the Service Diagnostics Transfix Drive Slow test. Do the Transfix Cam operate correctly? Replace the Process Drive. Verify the transfix cams are not damaged. If the error persists, replace the Transfix Cam Shaft.
1 Check that the Process Drive is properly aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 2. 2 Test the Tilt Axis Drive. Run the Service Diagnostics Tilt Axis Drive test. Did the test pass? Go to Step 3. Go to Step 4. 3 Check the Process Drive for damage, debris, or obstructions. Is there any damage? Replace the Process Drive. Go to Step 4. 4 Test the Process Drive Motor. Run the Service Diagnostics Process Motor Test. Did the test fail? Replace the Process Drive. Go to Step 5. 5 Test the Transfix Cams Run the Service Diagnostics Transfix Drive Slow test. Do the Transfix Cam operate correctly? Replace the Process Drive. Verify the transfix cams are not damaged. If the error persists, replace the Transfix Cam Shaft.