Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 4,024.42 — Xerox Phaser 8560 MFP

Code: 4,024.42

Description: Wiper Alignment Fault The following troubleshooting procedure applies to this error: 4,024.42 Printhead Wiper Blade misaligned
Causes: Head Maintenance Clutch, PL 4.0 I/O Board (2/2) - Media Drive Assembly, PL 4.0 Left Side Harness (2/2) - Wiper Blade, PL 2.0
Remedy: • Check Wiper Alignment. • Check damage, debris, or Ink build-up near the Printhead. • If the problem persists, follow the procedure below.
1 Test the Wiper alignment. Run the Service Diagnostics Check Wiper Alignment test. Did the test Fail? Perform (ADJ 2.5.1) and retest. If the test fails again, go to Step 2. Go to Step 2. 2 Test the Wiper drive. Run the Service Diagnostics Wiper Drive test. Did the test fail? Go to Step 3. Go to Step 5. 3 Check the Wiper drive and lock systems for ink, obstructions, or damage. Is the Wiper drive function correctly? Go to Step 4. Clear any ink or obstructions or replace any damaged components. 4 Check the Head Maintenance Clutch. Is there any oil, contamination, or obvious damage? Clean the interior of the system or replace the clutch if necessary. Go to Step 5. 5 Test the Head Maintenance Clutch. Run the Service Diagnostics Head Maintenance Clutch test. Does the clutch function correctly? Replace in order: Exit Module Media Drive Assy Wiper Blade Replace the Head Maintenance Clutch.

← Xem tất cả mã lỗi Xerox Phaser 8560 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie