Code: 7,009.42
Description: Printhead Restraint Fault A Process Drive or Printhead error has occurred. The following troubleshooting procedure applies to this error: 7,009.42 Printhead is tilted back, but not properly restrained.
Causes: Process Drive, PL 4.0 Right Side Harness / I/O Control - Restraint Arms, PL 2.0 Head Maintenance Clutch, PL 4.0 I/O Board (2/2) -
Remedy: • Check for obstructions or ink spills around the Printhead. • Check the Printhead Restraint Arms. • If the problem persists, follow the procedure below.
1 Check the restraints for damage or debris. Are the restraints damaged? Replace damaged parts. Go to Step 2. 2 Check the Printhead Wiper alignment. Is the Printhead Wiper properly aligned? Go to Step 4. Perform ADJ 2.5.1. 3 Check Printhead wire routing and the Tilt Gear. Does the Printhead move freely? Remove ink spills or reinstall the Printhead. Go to Step 4. 4 Check that the Process Drive is aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 5. 5 Replace the Process Drive. Does the error persist? Go to Step 6. Complete. 6 Test the Head Maintenance Clutch Run the Service Diagnostics Head Maintenance Wiper Clutch test. Does the clutch operate correctly? Go to Step 7. Replace the clutch. 7 Test the Wiper Drive. Run the Service Diagnostics Wiper Drive test. Does the Wiper Drive operate correctly? Replace the Exit Module. Repair the Wiper Drive.
1 Check the restraints for damage or debris. Are the restraints damaged? Replace damaged parts. Go to Step 2. 2 Check the Printhead Wiper alignment. Is the Printhead Wiper properly aligned? Go to Step 4. Perform ADJ 2.5.1. 3 Check Printhead wire routing and the Tilt Gear. Does the Printhead move freely? Remove ink spills or reinstall the Printhead. Go to Step 4. 4 Check that the Process Drive is aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 5. 5 Replace the Process Drive. Does the error persist? Go to Step 6. Complete. 6 Test the Head Maintenance Clutch Run the Service Diagnostics Head Maintenance Wiper Clutch test. Does the clutch operate correctly? Go to Step 7. Replace the clutch. 7 Test the Wiper Drive. Run the Service Diagnostics Wiper Drive test. Does the Wiper Drive operate correctly? Replace the Exit Module. Repair the Wiper Drive.