Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 2,006.xx — Xerox Phaser 8860

Code: 2,006.xx

Description: I/O Board Program Faults The following troubleshooting procedure applies to these errors: 2,001.69 The Electronics Module Failed to initialize. 2,002.61 Firmware program fault 2,003.62 Firmware program fault 2,004.63 Failure to start the Print Engine in Suspend Mode. 2,005.64 ROM read error 2,006.65 ROM read error 2,007.66 idiags entry point access error
Causes: I/O Board, PL 5.0.13 NVRAM, PL 5.0.9
Remedy: • Reset NVRAM and retest. • Check that all connections to the Electronics Module and I/O Board are secure by reseating each connection. • If the problem persists, follow the procedure below.
1 Reseat all I/O Board connections. Does the problem persist? Go to Step 2. Complete. 2 Reseat all Electronics Module connections. Does the problem persist? Go to Step 3. Complete. 3 Check ground integrity. Are the system grounds connected? Replace the NVRAM device. Reconnect the system grounds.

← Xem tất cả mã lỗi Xerox Phaser 8860

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie