Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 5,0xx.4x — Xerox Phaser 8860

Code: 5,0xx.4x

Description: Y-Axis Sub-System Faults The following troubleshooting procedure applies to these errors: 5,001.41 The Drum rotated once without a Drum Home Position Sensor activation. 5,002.42 The Y-Axis Encoder is faulty, or the Drum has stalled. 5,003.43 Problem in the Y-Axis sub-system. 5,004.44 Problem with the Y-Axis motion sub-system.
Causes: Y-Axis Belt, PL 2.0 Y--Axis Motor, PL 4.0 Electronics Module Power - Drum Assembly (Encoder) Right Side Harness / I/O Control -
Remedy: • Check for obstructions or debris. • If the problem persists, follow the procedure below.
1 Test the Y-Axis Encoder. Run the Service Diagnostics Y-Axis Encoder test from the Monitor menu. Did the test pass? Go to Step 2. Go to Step 3. 2 Check the Y-Axis Motor connection (P/ J18). Is the wiring faulty? Replace the wiring. Go to Step 4. 3 Check the Y-Axis Encoder wiring. Is the wiring faulty? Replace the wiring. Replace the Drum Assy. 4 Test the Y-Axis Drive. Run the Service Diagnostics Y-Axis Drive test. Did the test pass? Go to Step 5. Replace the Y-Axis Motor. 5 Test Y-Axis Belt tension. Run the Service Diagnostics Y-Axis Belt Tension test. Did the test pass? Go to Step 6. Replace the Y-Axis Belt. 6 Test the Y-Axis Motor. Run the Service Diagnostics Y-Axis Motor test. Did the test pass? Replace the Drum Assembly. Replace the Y-Axis Motor.

← Xem tất cả mã lỗi Xerox Phaser 8860

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie