Code: 7,006.4x
Description: Head Tilt Solenoid Fault A Printhead tilt error has occurred. The following troubleshooting procedure applies to this error: 7,006.xx The Head Tilt Solenoid is not activating the Head Tilt Cam, or the Printhead is not tilting properly.
Causes: Head Tilt Gear, PL 4.0 Head Tilt Solenoid, PL 4.0 Left Side Harness (2/2) - Process Drive, PL 4.0 Right Side Harness / I/O Control -
Remedy: • Check for obstructions or ink spills around the Printhead. • Verify the Printhead travels smoothly from left to right. • Check the Printhead Restraint Arms. • If the problem persists, follow the procedure below.
1 Check that the Process Drive is properly aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 2. 2 Reboot the system. Is the tilt-head activating the Head Tilt Gear. Go to Step 4. Go to Step 3. 3 Check for Ink spills on or near the Head Tilt Gear. Remove ink spills or reinstall the head-tilt and start over with Step 1. Go to Step 4. 4 Review instructions for 7,008.xx and 7,010.xx fault codes. Follow recommended actions for error codes and reboot the printer.
1 Check that the Process Drive is properly aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 2. 2 Reboot the system. Is the tilt-head activating the Head Tilt Gear. Go to Step 4. Go to Step 3. 3 Check for Ink spills on or near the Head Tilt Gear. Remove ink spills or reinstall the head-tilt and start over with Step 1. Go to Step 4. 4 Review instructions for 7,008.xx and 7,010.xx fault codes. Follow recommended actions for error codes and reboot the printer.