Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 7,009.42 — Xerox Phaser 8860

Code: 7,009.42

Description: Printhead Restraint Fault A Process Drive or Printhead error has occurred. The following troubleshooting procedure applies to this error: 7,009.42 Printhead is tilted back, but not properly restrained.
Causes: Process Drive, PL 4.0 Right Side Harness / I/O Control - Restraint Arms, PL 2.0 Head Maintenance Clutch, PL 4.0 I/O Board (2/2) -
Remedy: • Check for obstructions or ink spills around the Printhead. • Check the Printhead Restraint Arms. • If the problem persists, follow the procedure below.
1 Check the restraints for damage or debris. Are the restraints damaged? Replace damaged parts. Go to Step 2. 2 Check the Printhead Wiper alignment. Is the Printhead Wiper properly aligned? Go to Step 4. Perform ADJ 2.5.1. 3 Check Printhead wire routing and the Tilt Gear. Does the Printhead move freely? Remove ink spills or reinstall the Printhead. Go to Step 4. 4 Check that the Process Drive is aligned (ADJ 4.7.1). Is the Process Drive misaligned? Perform ADJ 4.7.1. Go to Step 5. 5 Replace the Process Drive. Does the error persist? Go to Step 6. Complete. 6 Test the Head Maintenance Clutch Run the Service Diagnostics Head Maintenance Wiper Clutch test. Does the clutch operate correctly? Go to Step 7. Replace the clutch. 7 Test the Wiper Drive. Run the Service Diagnostics Wiper Drive test. Does the Wiper Drive operate correctly? Replace the Exit Module. Repair the Wiper Drive.

← Xem tất cả mã lỗi Xerox Phaser 8860

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie