Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi 37,03X.4x — Xerox Phaser 8860 MFP

Code: 37,03X.4x

Description: PEST X-Axis Motor Faults An X-Axis Motor error has occurred. The following troubleshooting procedure applies to these errors: 37,030.45 The X-Axis Motor is drawing less power than expected. 37,031.46 The X-Axis Motor first phase is drawing less power than expected. 37,032.47 The X-Axis Motor first phase is drawing too much power. 37,033.48 The X-Axis Motor second phase is drawing less power than expected. 37,034.40 The X-Axis Motor second phase is drawing too much power.
Causes: X-Axis Motor, PL 4.0 Right Side Harness / I/O Control - Electronics Module, PL 5.0 Right Side Wire Routing (2/2) -
Remedy: • Check the X-Axis Motor connection. • If the problem persists, follow the procedure below.
1 Test the X-Axis Motor. Run the Service Diagnostics X-Axis Drive test. Does the motor operate correctly? Replace the Electronics Module. Go to Step 2. 2 Check wiring to the motor. Is the wiring damaged? Repair or replace the harness. Replace the X-Axis Motor.

← Xem tất cả mã lỗi Xerox Phaser 8860 MFP

Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie