Code: 10
Display: [Paper Jam 2] Check inside
Description: Paper has jammed in the paper exit area. 1. If the paper is completely fed out of the machine, but Jam 2 occurs: • The exit sensor is defective. Note: The exit sensor is mounted onto the SMPS/HVPS, PL 1. • After the paper is completely fed out, the exit sensor actuator, PL 5 should return to its original position to deactivate the photo-sensor. Sometimes it takes longer than it should and does not return to its original position. 2. If the paper is rolled up in the fuser , PL 5: • A stripper finger, PL 5 is damaged. • The heat roller or pressure roller, PL 5 is seriously contaminated,
Remedy: Clear the jam 1. Check the exit sensor actuator, PL 5. 2. Disassemble the fuser, refer to REP 9. Remove the jammed paper and clean the surface of the pressure roller, heat roller, and the stripper fingers, PL 5. Install new parts as necessary: • Heat roller, PL 5 • Pressure roller, PL 5 • Fuser, PL 5